Question about 490GS Treadmill Walking Belt
...treadmill.Is there anything I can check, is it the motor? Thanks V This definitely sounds like the drive motor. One way to check is to remove the drive belt and run the motor without the walk belt ...
Question about NordicTrack Treadmill, A2550
...motor shroud then plug unit in then start treadmill your going to use a flat tip screw driver as a stethoscope. Now place the flat on the motor at edge close to the flywheel put your on the handle ...
...treadmill remove the motor shroud. Use a long handled screwdriver and touch it to a non-moving portion of the front and rear rollers and motor and then put your ear up to the handle and the ...
...motor hood, then start the treadmill on power/speed level 3. Be very carefull, and use a broom stick (wooden) to put on the drive motor while it is running. You should be able to "feel" what you are ...
motor makes a loud grinding sound when operated. All works fine, but the noise is so loud that even with the sound turned all the way up, it is still hard to make out what is being said. I figure this
Question about Power Series 680 Treadmill Fitness Trainer
...the motor for your treadmill. Be sure that the power is remove before opening. because all treadmill's motor control circuits are live if there is ...
Question about Power Series 680 Treadmill Fitness Trainer
...treadmill makes loud grinding sound when I run in the middle of the tread. it doesn't make the noise if I run on the left side. 1)you must LUBE the DECK BELT, inmediately, for to avoid the ...
Motor making loud buzzing noise A motor on one of my precor c956i machines has a loud buzzing sound to it when turned up to higher and higher speeds. It still runs smoothly and stops normally and what
Question about C956i Treadmills with HR / WholeSale
...treadmill is making a roaring sound in front of the belt in the covered area making a loud roaring noise in front of the belt under the covered area Hello. This will be the motor bearings, without a ...
Question about RX6200 Treadmill Motor Control Board For Model Number:
...motor and front roller pulley After doing so, move the treadmill belt by itself by pushing it backward or forward with just your hands and listen for any noise, if you get any noise it is most likely ...
Usually answered in minutes!
346 Questions
191 Questions
188 Questions
214 Questions
122 Questions