Questions & Answers for: treadmill keeps going down

treadmill will go down until the motor stalls. Do a Calibration on the treadmill. Take out the safety key. With 2 fingers, hold down the stop button and the speed up or spped plus button. keep holding

going up and down. Treadmill strip not running I had the SAME problem, several times, with my NordicTrack A2250 Treadmill. Allow it to go fully up and then fully down several times, without turning it

...treadmill. Solution: If you get an error code, contact us [email protected] with the code and make and model and we will try to help you figure out what is going on. Typically we either find a loose ...

the belt won't move and the incline is stuck. display isn't working properly either reebok 8000es incline keeps going up and down and will not stop or go into any other mode

...menu start by pressing the pause button and keep it held down as you hit the clear button twice. The treadmill will reset and go into the service menu, and now you quite pressing the pause

...treadmill. Solution: If you get an error code, contact us with the code and make and model and we will try to help you figure out what is going on. Typically we either find a loose wire, an ...

going on. Typically we either find a loose wire, an intermittent short, a bad power board, or a bad control panel . Unplug your treadmill and then check all your wiring to make sure nothing is pinched

...treadmill will not go into sleep mode at all. It is supposed to enter sleep mode after 30 minutes of no use. You need to go into the maintenance menu. Take out the red safety stop key, hold down the ...

Keeps asking me select user, then it restarts again Took treadmill apart to move it. Reconnected it and now will not start. It turns on and screen lights up, then it asks me to select a user, I hit go

down for a few seconds. "CL11" will appear in the display of the treadmill. ·2 Press the reset button one more time with the Q-tip. "CL21" should appear on the screen. Press the enter key. The display