Questions & Answers for: treadmill incline stay

...treadmill at an incline of 4 OR 5. Now the incline is stuck at an angle and will not change or go back to zero. Check the motor and the gears that run the unit up and down. If is located on the front ...

...treadmill, I cannot get it to stay up. First foremost is the unit incline to zero degree if not power up the unit hit the start and use the quick incline zero button. Now if that does not resolve the ...

...treadmill at max incline and walk on it at 3 MPH. If the treadmill operates normally at max incline but bogs down at minimum incline, replace the walking belt. Gravity takes over for the drive system ...

...problem. Remove hood and find the plug for the incline motor, disconnect and then reset treadmill. treadmill should work but will not incline until incline motor is repaired or replaced. Good

...treadmill that we have is stuck on incline. How do I get it to go back down? This happened to my treadmill. You need to get to the motor and see if the belt is fraying. If so, the fibers may have ...

incline motor stays on going down, and will not respond to the controls. healthrider R 60 could be bad incline sensor or c/board is going bad. one more try bipassing the board with power to the ...

...treadmill belt begins to move. Both the speed and incline should go through their full range from lowest to highest, and then back down again. Step 4 Repeat the process if the display does not read ...

...treadmill incline raises and stays in place. if on treadmill, when pushing an incline 3 ie:5, bed raises, pauses, then lowers back down but continues to register 5.  incline Motor is not working ...

incline doesn't work My treadmill won't stays in the incline position can't get it to come back down

treadmill is stuck in the fully elevated (level 12) angle on the platform and will not move The incline motor is jammed due to a faulty incline sensor or incline motor assy. This is somewhat hazardous