...Tray 3] Paper Source: PC-103, PC-203 [Tray 4] Paper Source: PC-203 [LCT] Paper Source: PC-403 I do not understand what is happening and how can I enable the trays back so we can print from them? ...
Question about bizhub C250 All-In-One Laser Printer
...tray 3. With the copier turned on do the following Open paper tray 3, remove paper, close tray, open then shut front door, load paper into tray 3 - hey presto!! If the fault comes back you could have ...
Question about bizhub C351 All-In-One Laser Printer
...tray 3 paper could not lift up to the feed rollers. open the tray and check the paper tray and checkthat the paper is loaded correctly pull all the paper out of the tray and check to see if any is ...
Question about magicolor 2400 Laser Printer
tray and printer stops after printing 3 or 4 pages. I open and close the top access and printing resumes for 3 or 4 more pages...stops and shows paper jam at feed tray. Repeat open and close of access
..."Tray" button or "Paper" button from the panel. 2-Select the paper size from the menu shown. 3-Now press the start button. No caution will appear.Next time use the same procedure for making
Question about PRINTING - Bizhub-250 Minolta 25ppm Printer/Copier/Scanner/Fa
...gear.Remove the misfed paper and push in the tray ,open and closed the right door and the copier must be ready. C 0204 - 2nd tray C 0206 - 3 rd tray C 0208 - 4th tray C 0211 - bypass tray Good
...to shut off sub power and restart. Tray 3 has no blockage- but whn restart, immed get the same error code c-0214 C0214 Image transfer voltage problem refers to high voltage - will need a service ...
BIZHUB C350 ERROR CO206 C0206 Tray 3 feeder up/down abnormality • The tray 3 upper limit sensor is not blocked even after the lapse of a given period of time after the lifting motion has been started.
Question about bizhub C351 All-In-One Laser Printer
...WITH ERROR CODE C0206 C0206 Tray 3 feeder up/down abnormality • The tray 3 upper limit sensor is not blocked even after the lapse of a given period of time after the lifting motion has been
Tray 3/4 feeder transportation motor turning at abnormal timing The lock signal remains LOW for a predetermined continuous period of time while the motor remains stationary. 1) Check the M25 connector
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions