transmission hesitates each time it goes into gear and it clunks. It is a Accent,Hyundai 08 Hyundai has a TSB for this: 07-40-010 - AUTOMATIC TRANSAXLE HARSH AND/OR DELAYED UPSHIFT OR DOWNSHIFT". This
...transmission work I need? thanks computer need to be reset dealer only,autotransmission shouldnt need flushing ever unless a brake band starts breaking up ,then its a strip job and rebuild .put a ...
will not shift into overdrive try disconnecting the battery negative terminal for about 15 minutes, then replace it and drive the car. The "brain" may reset and allow the transmission to shift.
...transmission just follow the wire and ull find the second sensor under the transmision, once replaced, i let the key to on position for 15 min to reset the computer ,and ur good to go..car runs like ...
...transmission just follow the wire and ull find the second sensor under the transmision, once replaced, i let the key to on position for 15 min to reset the computer ,and ur good to go..car runs like ...
...15 min to reset the computer ,and ur good to go..car runs like new again..hope this helps ... Marcos U will need to have the transmission rebuilt, once OD starts to slip that is it for the ...
...reset the transmission shift points and the auto relearn sequence. So it has to be an actual mechanical problem. I don't want this problem to cause an accident, or damage the vehicle any further. ...
...transmission rebuilt and replaced shift solenoids along with rebuild kit, end clutch, torque converter, front pump, front drum, bands, pulse generators and still have this same stupid codes wich ...
Question about Motor 2004 Accent
...reset the celinode. i am sure if i was tapping the right location on the starter. where on the starter do i tap to get some results so I can start the car so I can drive to a mechanic shop. If it's ...
Question about 2005 Accent
...something major? Please help or advice me. Thanks run the fault codes to find the sensor that has the light on. it can be either engine or transmission fix the fault and reset the ECM using a scan ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions