Questions & Answers for: GMC Sierra transmission lever

...your shifter cable is the cause for your problem. if the cable is ok and you can see the shift lever move on the transmission than the next likely cause would be the valve body in the

Ad

lever around but it acts like its in park. it happend this morning, i backed out of my parking spot then shifted into park for a second, after that it wont move. i checked the fuids, infact i just had

Ad

...transmission lever were the cable attaches to. If it shifts into every other gear just fine the locking parking pawl has been worn away or broken. The pawl has a pointed 90 degree end that catches ...

...lever activation or NO auto-4wd on button]]] system takes automatic transmission fluid dexron III use DEXTRON III,transmission fluid (GMP/N 12346143 or equevalent) nv241 transfer case 3.13 lit.(2.25 ...

Question about 1997 Sierra

1 Answer

lever through each gear range for about 3 seconds. Place transmission in PARK position. Set parking brake and allow engine to idle for 3 minutes. Remove the transmission fluid level indicator and wipe

...transmission. It the lever moves just as the person moving it says their doing then the cable and shifter are Okay. if not the cable or it's mountings need to be looked at to see where they came off ...

...transmission mount oil level ok The gear shift lever indicators tell you what gear you have an automatic transmission in on your vehicle. The shift solenoid tells the transmission when to shift gears ...

...lever moves freely and stuck in drive. Figure cable broke. Easy fix?? I will have to crawl under truck to put in park so can start it then in drive to get it to shop. Easy fix? Correct. Check the ...

...lever in park without coming to a complete stop on a downward incline. Sounds like you probably bent the "detent" in the transmission. You'd need to drop the trans pan and replace the linkage ...

...transmission seal how do I change the rear seal in my tranny remove the drive shaft . drill a small hole in the seal face and insert a self tapper screw in it . Use something like a slide hammer or a ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 GMC Sierra
1998 GMC Sierra

987 Questions

1997 GMC Sierra
1997 GMC Sierra

847 Questions

2000 GMC Sierra
2000 GMC Sierra

676 Questions

1999 GMC Sierra
1999 GMC Sierra

601 Questions

1994 GMC Sierra
1994 GMC Sierra

604 Questions

Manuals & User Guides

Loading...