Questions & Answers for: Harley Davidson transmission lever

lever at transmission stripped. can it be removed and replaced without inner and outer primary removal No, you must remove the inner primary to replace the shift lever. But, that may not be the end of

transmission in neutral, lift the shifter lever with your hand until just before it shifts. Feel the spring tension. Now, depress the lever until just before it shifts into first gear. Does the spring

...transmission just forward of the shifter shaft lever. It is behind the outer primary which makes getting to it difficult without the special tool. To check it, with the engine off, gently depress the ...

lever you shift the transmission with) temporarily on the shift shaft and support it some way so as to hold it level. Install the transmission. Now, before finishing the installation job, check to see

...lever on the transmission. The shift levers get worn and no longer shift the transmission like they should. You'll have to remove the outer and inner primary to get to the lever to replace it. If the ...

...lever on the transmission. This is the shift lever that connects to the shifter pawl shaft. I"ve seen lots of them get worn to the point that they feel like they are going to fall off. When they get ...

...lever until the transmission tries to shift. Notice the distance. Now do in the other direction, pull up like you're going to second gear. Notice how far the shifter goes before it is stopped by the ...

lever on the shifter pawl shaft of the transmission has worn is loose. Start at the foot shifter and find the rod that is going back towards the rear of the bike. Follow the rod back until it connects

lever on the transmission. Take the nut off and take the rod loose from this short lever. Then, move the forward like you are going to shift into low gear but don't actually shift the transmission

REPLACE TRANSMISSION SHIFT LEVER 06 ROADKING SHIFT LEVER ON TRANSMISSION SHIFT SHAT IS STRIPPED, CANNOT TIGHTEN.