Questions & Answers for: Ford transmission lever

...transmission control switch (TCS) detent. Loosen manual control lever-to-control cable retaining nut. Move transaxle manual control lever to OVERDRIVE position or D (DRIVE) position on vehicles ...

...transmission lever to the park position with the following results. 1.- The truck started 2.- Transmission engaged: Reverse, Neutral,and Drive. Good? not so; I tried to put the transmission in park ...

...located On the side of the transmission. Look at the lever that the shift cable pulls on. The transmission range sensor is the black assembly under that lever with the wire connector going to

...26 7A216 Transmission Shift Selector Position Insert 27 7302 Transmission Selector Lever Arm and Support 28 7E395 Shift Cable and Bracket 29 7210 Gearshift Lever 30 3E691 Steering Column Lock ...

...transmission selector lever in N or P. If it is the: C3 And A4ld Transmissions It's on the transmission.... Neutral start switch and its location on the C3 and A4LD transmissions Yes it is a hex ...

...lever and transmission manual lever in the(D) position, tighten the nut at point A to 17-24 Nm (12-18 ft-lb) torque. Use care to prevent motion between the stud and rod. Remove the three-pound force ...

...transmission lever to neutral, then with firm pressure push lever forward so you feel 2 distinct notches/detents forward, the lever is now in park.  Push locking clip back into position once you ...

...and transmission. Determine where the sloppy looseness is. Replace sloppy linkage parts if transmission lever is not loose. Pray you don't need to have shifter leverage (inside transmission)

transmission end selector lever is accessible, disconnecting the cable or rod from the lever and moving it by hand will provide a clue whether the problem is inside the box or the cable or gear lever.

...sure it is moving the lever on the transmission. It is apparent the transmission is stuck in drive mode and the lever or cable changing modes is not connected either at the shifter or