Questions & Answers for: transmission lever

Ad

...transmission control switch (TCS) detent. Loosen manual control lever-to-control cable retaining nut. Move transaxle manual control lever to OVERDRIVE position or D (DRIVE) position on vehicles ...

Ad

Question about 1984 American Motors Eagle

2 Answers

...transmission shift lever stud ball. Install the retainer to the shift cable and transmission bracket. Feed the shift cable through the floor panel. Lower the vehicle. Adjustment Procedure Ensure that ...

Ad

...lever. a transmission control switch on the transmission range selector lever. a cable connecting the transmission range selector lever to the transmission manual control lever. a brake/shifter ...

Question about 1997 Cougar XR7

1 Answer

...lever clicks, the transmission is in second gear. The second time the lever clicks, the transmission is in the "drive" position. Tighten the single nut which attaches the end of the transmission's ...

Question about 1998 Econoline

1 Answer

...26 7A216 Transmission Shift Selector Position Insert 27 7302 Transmission Selector Lever Arm and Support 28 7E395 Shift Cable and Bracket 29 7210 Gearshift Lever 30 3E691 Steering Column Lock ...

Question about 1988 Bronco II

2 Answers

...transmission selector lever in N or P. If it is the: C3 And A4ld Transmissions It's on the transmission.... Neutral start switch and its location on the C3 and A4LD transmissions Yes it is a hex ...

Question about 1988 Bronco II

1 Answer

...lever and transmission manual lever in the(D) position, tighten the nut at point A to 17-24 Nm (12-18 ft-lb) torque. Use care to prevent motion between the stud and rod. Remove the three-pound force ...

Question about 2006 FLSTNI Softail Deluxe

2 Answers

lever on the transmission. Take the nut off and take the rod loose from this short lever. Then, move the forward like you are going to shift into low gear but don't actually shift the transmission

Question about 2006 FLSTNI Softail Deluxe

2 Answers

...lever on the transmission moves through the full range but when the cable is attached at both the transmission and the shifter lever inside I can't get the full range. When I put the lever on the ...

Question about 1996 Corolla

1 Answer

...transmission, 5-Speed. - ECM Engine Control, M/T. - Transmission oil SAE 75W85, 2.5 Litres. - Clutch pedal assembly. - Gear lever assembly, with console. - Gear lever cable set. - Gear lever boot.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

john h

Level 3 Expert

22402 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...