Questions & Answers for: Cobra transistor nb

...Radio dude, What you have is a blown am regulator. The sideband side does not use the mentioned transistor. They use a few different numbers here for the am regulator. One of them is a 2sc1419.

i have a cobra cb and it makes a weird sound all the time, when i accelerate the sound gets biger What you are getting is ignition noise from the engine of your car. Could be spark plug noise or ...

NB-ANL buttons what are there funtion? NB-Noise blanker this helps elemenate noise in the receive.ANL-Automatic noise limiter wich does about the same thing as the Noise blanker.

not transmitting or receving (transistors burnt out) how do i figure out the codeing on the transistors to replace them with the proper ones if its not transmitting or receiveing its probably a ...

what exactly does the anl nb/anl button do on my cobra 29 wx nw st ANL stands for "Automatic Noise Limiter" and NB stands for "Noise Blanker". The ANL gets rid of a lot of interference noise caused by

alright i have a cobra 29 LTD classic cb radio i recently bought and i am trying to put it in my 1985 ford ranger i have it grounded to the frame on the negative side i have the positive ran into the ...

...model and have accidently overheated it by having a amp on top of it. It apparalently has a blown transistor and the shop in nz here is having problems in locating one.If i was to find out wht the ...

key to tx-green lite out-no output power or red lite rec ok It could be small transistors--in the back where the light and transmit hook up. One small transistor will shut down transmit & possibly

...talk out wat could be wrong mic has been tested and is good The only other area is check the RF out transistor "usually heat sink-ed to the chassis" check for open traces on the circuit board, bad ...

...don't recommend ANY changes to the output power more than 4W on AM of a stock CB radio. The output transistors can be run a bit harder, but the likely hood of them dying is much greater. ...