Questions & Answers for: GMC Yukon Denali transfer case clunking

...transfer case? please advise. thanks the jerking and noise you are experiencing is the drive chain and bearings in the transfer case also you may want to check the end play in both front and rear ...

DEALERSHIP.THEY WILL HAVE TO REPROGRAM THE TRANSFER CASE CONTROL MODULE.WHEN YOU DISCONNECT BATTERY BY YOUR 4WD BEING COMPUTER CONTROL ALSO IT LOST MEMORY TO SHIFT IN AND OUT 4WD.DEALERSHIP HAS TO FIX

I have a 2002 Danali XL. I am having a transmission issue. When I am using revers, then switch to drive, I am hearing a rather large 'clunk' in the trany. If I don't let it completely catch into drive

...transfer-case actuator, the connections may be corroded at the actuator harness as well. Check for corrosion first. MY 4X4 does engague for about 100 feet, then locks up. Now i have a noise comming ...

i need the name of the part that makes it 4x4 transfer case

...Transfer case... No Luck... I checked the brakes for anything binding.. No luck I replaced the upper steering shaft... No Luck... I did find a post like mine where it was fine cold but after about 15 ...

4x4 problems transfercase stays on the shaft going to front axle stays on If you have locked hub drive in the front end then that shaft will be turning all the time when moving as the front wheels ...

...fuse box Possible shorted decoder motor on transfer case. Unplug the connector at the motor and see if the fuse still blows when 4x4 selected. If fuse is good, suspect decoder motor shorted ...

transfer case problem on 2006 gmc Denali. When I turn selector 4wd drive, light flashes for a few seconds then hen goes out. The same on the other settings.. speed may be a factor, try pushing the ...

i have a 2003 yukon denali i hear a clunking noise, it sounds like it is coming from left rear. i can fell it in the floor board under the the floorboard i have a 2003 yukon denali i hear a clunking ...