transfer belt unit for paper on it or behind it. You can simply remove it by first removing your fuser unit (lock is under fuser, a turn dial) then pull the transfer belt out and tilt up. **** Warning
transfer belt unit Open the door on the left side of the copier. Remove the fuser assembly by unscrewing the large knob underneath the fuser. Lift it out. Careful it will probably be hot! The transfer
Question about MX-3501N All-In-One Printer
...TRANSFER BELT HI HAVE SHARP MX 3501N COPIER ,BELT CRACKED AND TORE TRANSFER BELT UNDER THE TONER CART. JUST ABOVE ROLLERS WHICH TRANSFER BELT OR UNIT IS THIS AND WHERE CAN I BUY UNIT OR REPLACEMENT ...
...try a new toner cartridge or check and see if the shadow is on your toner. If it is on the new toner/transfer belt, then the electrical system is not completely discharging your toner/transfer
...transfer belt has gone past 100,000. The belt has reached the end of its' rated life. You could clear the counter with Sim 24-4 but your copy and print quality will change. Eventually your belt will ...
...transfer belt unit. If it still comes back, sorry dude you're out of luck. Your copier can't swing the hinged portion of the transfer belt on and off your color drums because a badly designed ...
Maintenance TK1 TK1 Primary transfer unit counter has reached preset value or number. To correct error, replace primary transfer belt/rollers. Enter calibration/diagnostic mode and reset counter.
...transfer belt unit, change in the separation position sensor characteristics is not detected within the specified time. Section PCU Case 1 Cause Harness connection trouble between the PCU PWB and the ...
Question about Mx-2300n Copier Color Mx2300n Printer Scanner
...transfer belt unit, change in the separation position sensor characteristics is not detected within the specified time. Section PCU Case 1 Cause Harness connection trouble between the PCU PWB and the ...
Question about Mx-2300n Copier Color Mx2300n Printer Scanner
...transfer belt unit is not installed. Remedy: Use SIM6-3 to check the separating operation of the transfer unit. Install the primary transfer belt unit. Replace the transfer unit position sensor. ...
Usually answered in minutes!
1,105 Questions
603 Questions
557 Questions
331 Questions
354 Questions