...unit, if it doesn't activate it within it's specified time it will stop the machine, causing a jam. thirdly is may be the transfer/ seperation issue, there also a couple of transport belts that may ...
...Transfer Belt pressure/retraction failure please have this services as this is a part of the printer that is not consumable. Code Item C0000 Main Motor?s failure to turn C0001 Main Motor turning at ...
...Transfer belt unit EEPROM error No response is issued from the device in reading/writing for 5 ms or more and this problem is repeated five times successively. Mismatch of reading data from two ...
transfer belt Did you run the toner install after you replaced all of the parts???? With out running that the developer will not have toner in it. I would also try to put the old developer unit in and
I double checked the part numbers to ensure the correct ones were installed. The machine does not know the transfer belt is in the machine. Either or both of the replacement boards could be defective
transfer belt shift error. On the new Alphard series, the transfer belt has a mechanism to center the transfer belt, in case it starts to walk off one side of the pulleys. And it works great until you
Question about Km-8030 With Feed, Bank, Print, Scan - 318k Copies
...transfer belt is locked up: 1. To check the motor operation, execute U030 Belt Meand (see page 1-3-34). 2. Rotate the drive gear, the belt and the roller by the hand and check that they are not ...
Usually answered in minutes!
223 Questions
192 Questions
168 Questions
156 Questions
143 Questions