...transfer belt unit ? Pin 3 (CN25 on engine control board) unable to send signal ? Defective transfer belt tension unit 1. Replace the transfer belt unit. 2. Replace the engine control board. 3. ...
...transfer belt unit Replace the transfer belt unit. Defective transfer belt tension unit Replace the transfer belt tension unit. Defective toner cartridge drive unit Replace the toner cartridge drive ...
...transfer belt?s cleaning unit - Timing & Condition ? When the belt cleaning section touches the image transfer belt, but the belt cleaning sensor signal remains LOW. ? When the belt cleaning section ...
...Transfer belt contact error The transfer belt contact sensor does not detect the movement of actuator at the sensor while the polygon motor rotates. ? Dirty transfer belt contact sensor ? Defective ...
Question about Aficio CL2000N Laser Printer
...transfer belt unit. Defective transfer belt tension unit. CN25 Pin 3 on the engine board is unable to send a signal. Suggested fixes: Replace the transfer belt unit. Replace the engine control board. ...
transfer belt needs to be replaced. They get scratched up and milky looking and the sensors can't see the color reg marks good enough. It could be other things also but the transfer is a good place to
...transfer belt error" Turn machine off (unplug), reseat the transfer belt, and try again. If the problem persists, clean or replace sensors, replace the belt, or replace the motor. Check the contact ...
Question about Aficio CL2000N Laser Printer
...transfer belt message on a Ricoh CL2000 You'll have to replace the transfer belt with a brand new one in order to clear that message. Installing a transfer belt from another machine won't clear it -- ...
...transfer belt. WEhat's Ricoh part number? And where might I find one? http://www.precisionroller.com/transfer-belts-for-ricoh-aficio-cl7300d/products.html ...
Question about Aficio CL7300D Laser Printer
...Transfer belt It's purely mechanical problem. Kindly check the proper position of the transfer belt and check very well if there is a particular part that is not properly fixed or out of position. ...
Usually answered in minutes!
267 Questions
215 Questions
218 Questions
178 Questions
117 Questions