Questions & Answers for: Suzuki transaxle

forenza? I got the drain plug out but I can't get the other plug out? Help! Once you've drained the transaxle by removing drain plug, re-install drain plug and torque to mfg. specs. To fill transaxle,

Where can I find transazle id numbers for a 07 Forenza manual transaxle? My sons is stuck in 4th gear and shifter moves like nothing is attached to it, but can hear noise in transaxle when you move ...

...plug on 2007 suzuki forenza Raise vehicle and support with safety latches/jackstands, etc. The transaxle fill plug is located above the location where the passenger c.v. halfshaft enters into

i have a leak coming from inside the bell housing of my transaxle leaking onto my clutch making it slip new clutch replaced less than a week ago and rear main seal replaced oil smells like gear oil ...

...suzuki swift located and where do i fill it up? LEVEL CHECK With Oil Level Gauge Fig. 1: Manual transaxle oil level check - with level gauge Drive the vehicle to bring the transmission up to ...

...fsm quote ( only an ecerpt, not COMPLETE< READ THE BOOK. Important: Routine inspection of the transaxle fluid is not required. Transaxle fluid inspection is only required if there is a symptom ...

...stick clutch phase 1: Before servicing the vehicle, refer to the Precautions section. Drain the transaxle oil. Remove or disconnect the following: Battery cables (remove car battery first or NEG ...

...coffee cans. This will prevent confusion during installation. After unbolting the transmission or transaxle, always make sure it is properly supported. If it is necessary to disconnect the air ...

...the vehicle, refer to the Precautions Section. Disconnect the negative battery cable. Drain the transaxle oil. Remove or disconnect the following: Clutch operating cylinder with hose still ...

...deal. The typical half-shaft remover is a fork that fits between the inner CV's housing and the transaxle case. The fork is attached to a slide hammer, only takes a blow or two to pull the ...