...from area around the dipstick. Then take out the dipstick and check the condition of the fluid. The transaxle should be overhauled under the following conditions. a.If there is a "burning" odor. b.If ...
Question about 2003 Santa Fe
...on a evo This is a 2003 Evo VIII All 1996 Model Year and newer vehicles equipped with manual transaxles except Accents , which have the "push" type clutch system.SERVICE PROCEDURE: Drain the ...
...up to something that won't let me drop it. i need to know what it can be that i have to remove. Transaxle Removal & Installation Before servicing the vehicle, refer to the Precautions
wiring automatic transaxle Elantra 1997 Hi..I'm from Venezuela. My car: 1997 Hyundai Elantra w/ Automatic transaxle. Need to know how to connect cables from my recent mounted transaxle and the "gear ...
...the axle hub outward and separate the driveshaft from the axle hub. 8.Insert a pry bar between the transaxle case and the tripod joint case, and pry the driveshaft from the transaxle case. ? Be sure ...
...speedometer. On 2004-2005 vehicles, the vehicle speed sensor is attached to the output shaft of the transaxle. On 1996-2003 vehicles, the vehicle speed sensor is built into the speedometer. On ...
...may not be your problem but it does bring the vehicle in fail safe you may have a warranty Group TRANSAXLE Number 09-AT-016 Date AUGUST, 2009 Model 1999-SONATA 2001-ELANTRA, SANTA FE & XG ...
...speed sensor unit on my 2001 sante fee VECHICLE SPEED SENSOR ATTACHED TO THE OUT PUT SHAFT OF THE TRANSAXLE. Here is a picture of where the speed sensors (pulse generators) are located, there are 2 ...
Question about Motor 2004 Sonata
i have an 2007 hyundai accent with a bad transaxle output shaft bearing, my question is do i have to remove/open transaxle to replace or can it be done with engine transaxle in car 2007 hyundai accent
Question about Motor 2004 Sonata
how do I replace my 2004 Hyundai Elantra reverse light sensor switch if this is a manual transaxle the reverse lamp switch is just behind the battery box beside the slave cylinder mount. if this is an
Usually answered in minutes!
1,503 Questions
1,180 Questions
1,131 Questions
1,254 Questions
1,082 Questions