Trailblazer 4.2L L6? And how do I clean? The throttle body is the box connected to the intake manifold. It is connects the air intake system to manifold. You will see your throttle cables connected to
...trailblazer but I was wondering if I can not find the object after using the Telescoping magnetic retrieval tool and have to take it to a repair shop could it mess up the engine if driven? yes it can ...
...trailblazer 2.2L & 2.4L Engines Turn OFF the ignition. Drain the coolant system to below the ECT sensor. Disconnect the engine coolant temperature (ECT) sensor electrical connector. Carefully ...
rapping noice, sounds like a lifter...how hard is it to fix without going to garage do to the complexity of the 4.2 dohc engine i am pretty sure you will find that you have a worn lobe on the cam ...
trailblazer 250 wont start it has fire, and gas, oil but i dont know if maybe the compression is gone? If you have oil and gas and it will fire then try a new plug. A bad plug when removed will appear
...ignition coil on a 2004 chevy trialblazer? remove the air filter assembly and look at the back of the engine, disconnect the wire plug and 2 bolts that holds the coil assembly to the intake
...KNOW HOW TO TAKE A BRACKET OFF THATS HOLDING INTAKE MANIFOLD ON A 2002 CHEVY TRAILBLAZER It's that big black case that runs along the right side of the engine (where the throttle body is hooked
intake manifold) needs to be removed and cleaned. Also clean any soot on the head intake runners. And replace intake gasket. Be sure to remove all sensors from the intake before you clean it. Use rags
Question about 2005 TrailBlazer
how do i remove the intake manifold on a 05 trailblazer in line 6 without going into detail buy a Haynes manual and it will show you
Where is thermostat located on 2008 Chevy trailblazer Is located under the intake manifold follow the driver side radiator hose I believe you need to remove the alternator
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions