Questions & Answers for: Jeep Wrangler tps sensor

...Sensor (TPS),i would go back and have it scanned again,this will tell you for certain what it is.Try and get the code number and definition written down.If it were TPS again,the sensor itself would ...

...down from driving it will stall out when im braking. please help check maf and tps sensor check idle air control, tps & map sensor. As usual with electronics, test test test before buying

...TPS SENSOR.PROBLEMS.SCAN IT.TO LOOK FOR TPS FAULT CODE.ALSO CHECK TPS SENSOR WIRING.AND MAKE SURE ITS NOT LOOSE. I have a 05 TJ, twice the check engine light came on with a OBDII code of P0068, first ...

...TPS, should read .50 volts at idle, also could be defective sensor. computer scans r an aproximation to whats goin on.systems r so complex today that more then 1 r needed.scanning devices vary in ...

...replaced TPS and CRANK SENSOR runs like a dream, had high voltage on tps, spitting, sputtering, bucking on take off. anything higher than 4.97 volts from computer will set off check engine

...position sensor,but when map sensor was changed it no longer showed TPS. The problem is one of your coil packs is bad. Don't throw money into sensors, they are false codes. The problem is coil

...TPS (throttle position sensor) is reporting too high a voltage. Symptoms may include: Rough idle High idle Surging other symptoms may also be present A code P0123 may mean that one or more of the ...

...near TPS SENSOR( throttle position sensor)...unplug with engine running to see if there is an idle change..also it could be the TPS SENSOR sticking.and check to see if all vacum lines are

...A faulty MAP sensor itself or a bad TPS (throttle position sensor). It's not uncommon for a bad TPS to idle when the motor is cold but once warm, not idle fast enough to keep the vehicle

...map sensor location on motor I have a 94 jeep wranger just started to idle at 3000-3500 rps checked the tps and tbi no change but remove the vacuum line to map sensor idle lowers 2000 but runs ...