...of diagnosing problems. since 1909. new fuel filter is part of that. then. slight hesitation is bad TPS. low fuel pressure. bad maf, stuck fuel pump reg. slipped timing belt. there is huge list and ...
...the convertor to see if it is clogged but is still doing the same thing. Plugs, wires, distributor cap, and rotor button were changed also. What should I check next? TPS - throttle position sensor
tps sensor fail They are battery powered. When the battery dies, you have to change them. The reader for them to be tested is usually at a tire shop or dealer. why not post a real question, and not a ...
...the gas. Usually the problem is a faulty TPS, the sensor is out of adjustment, or there is a problem with the wiring harness. The sensor should read less than one volt with the throttle plate
Question about 1994 Tracker
...TPS sensor and forgot to mark each wire. The TPS has 4 wires that run from the sensor to a 6 pin plastic connector. There 2 additional wires, a red and a yellow, that run from the 6 pin plastic ...
calibracion de tps con actron parametro de tps co elite auto scanner cp9185 actron what car, tracker, 97 G16b MPI, the TPIS calibration is ...
...sensor? Or maybe the fuel pressure regulator. When the distributor was set too high, there was no hesitation but smelled like it was running rich. Any advice would be welcome. 92 which G16 engine, ...
...tps how you know if throttle sensor is bad old post. but.... a great question, but on a tracker , the TPS , has 2 parts inside cascaded as one part. so that makes answers harder. the tests are ...
Question about 1991 Tracker
how to replace the tps on a 1991 tracker? the one i bought has 4 wires the one on the tracker has 6 wires the 1991 G16a has a pig tail connector, must have 4 wires. and shares the Injector connector ...
Usually answered in minutes!
350 Questions
228 Questions
207 Questions
191 Questions
187 Questions