Questions & Answers for: Dodge Ram 1500 tps sensor

tps sensor by using a voltmeter and back probing the tps connector. there are 3 wires with the connector tange facing up, the 3 wires are sensor ground (the wire closest to you) the middle wire is the

...Sensor (TPS) or Manifold Absolute Pressure (MAP) sensor. If 5v is not present, unplug the Crankshaft Position (CKP) Sensor. Turn the key off for 10 seconds. Turn the key on and measure the voltage on ...

...tps, cap,rotor, plugs and wires. Can a MAP sensor cause a mis-problem? Yes a Manifold sensor can cause this problem. Most likely I believe it would be a cam shaft sensor or a oxygen sensor. Have had ...

tps sensor to monitor throtlle opening, accel and decel, what has happened the tps has a worn out spot in cruise area, hence the down shift, uphill is fine because your past the worn out spot, replace

...TPS ( throttle position sensor)? The automatic transmission uses throttle position sensor to determine position and opening of throttle, and to decide when to shift into gear. IF throttle position ...

tps sensor correlation code, essentially it means the map sensor reading isn't what's expected with the tps reading and vice versa! It sounds like your tps sensor is probably bad or the circuit to one

...sensor (TPS) and usually a ground also. A general measurement is: at idle = .5 Volts; full throttle = 4.5 Volts. If the PCM detects that the throttle angle is greater or less than it should be for a ...

Show me were the tps sensor is on a 2003 dodge ram 1500 5.7 hemi TPS SENSOR LOCATED LEFT SIDE OF THROTTLE BODY.

...tps sensor can u show me were it is at on a 2003 ram 1500 5.7 hemi http://imageshack.us/photo/my-images/708/dsc00225ny.jpg/ The TPS is part of the TB on the 5.7 hemi, as shown in picture. I hope this ...

...this will occure when the tps is going out jst change the tps (throttle position sensor) and it should stop if you dont their will come a point where you will have prob getting the engine to even ...