...TPS sensor for 3.4l motor I need to replace the TPS Sensor for my grand am GT 3.4L. Only one problem. I have no idea where it is located on the car. Can someone please give me some direction? where ...
Question about 1997 Grand Am
...sensor ( tps). or in the wiring or connector, most likely its the tps that is bad. first remove connection from tps, heres how to test. use an ohms meter and hook a lead to top or bottom terminal of ...
...sensor(TPS) if it is on the side of the throttle body in-line with the butterfly it is a TPS. If it is inside the air intake tube it is a MAF sensor but those are usually either in the intake after ...
...sensor). If the TPS is faulty the result is a late response or unresponsive throttle. One good reason why it won't go. The TPS is connected on the throttle body. Have the TPS replaced and you'll be ...
...in gear and push on the gas it just dies a defective tps sensor could cause this kind of defect..tps is the throttle position sensor..located at the intake manifold connected in the accelerator ...
Question about 1994 Firebird
...tps sensor and my egr v i need have a problem with cat. but i has been fixed . no vacum leaks i have even replaced the ems sensor. i now its a fuel problem or a vacum problem. ive changed the fuel ...
...sensor (TPS) and usually a ground also. A general measurement is: at idle = .5 Volts; full throttle = 4.5 Volts. If the PCM detects that the throttle angle is greater or less than it should be for a ...
...intake, TPS is the throttle body position sensor, the CAM is the cam shaft position sensor (transmission), IGN ignition position sensor and the CRANK sensor is located near the bottom driver side ...
Question about 2003 Montana
...TPS sensor. I replaced it and the ideling problem went away but it is not shifting properly (it doesnt shift to 2nd until 6000 rpm andd hasnt sifted to drive at all) Is it possible that the new tps ...
Question about 2000 Grand Prix GTP
TPS sensor. If you have fuel pressure enough to start the car, then you probably have pressure always. Before turning the key to start, turn to ON. You should hear the fuel pump pressurizing the lines
Usually answered in minutes!
1,771 Questions
1,538 Questions
1,504 Questions
1,435 Questions
1,496 Questions
