Questions & Answers for: Buick tps sensor

Question about 1993 LeSabre

1 Answer

TPS

...TPS. (I have a 93 Buick eSabre.) Thanks, Cesare turn on car and use voltmeter on the sensor get the base reading then get a reading with the throttle partly opened and see if it increases or what. it ...

Ad

...tps sensor i went to the shop and they told me 2 things popped up on diagnostics: p1650 qdm 2 failer p0122 tps sensor what are these problems? and how much to fix? TPS is Throttle Positoin Sensor ...

Ad

Question about 1994 Park Avenue

1 Answer

...towards motor. You should see your throttle cable. Look closely you should see tps. You will need a phillips screwdriver or possibly a torx bit socket. Unplug sensor connector first. then remove ...

signal IF YOU HAVE CLIMATE CONTROL AC SYSTEM. WHERE YOU USE ELECTRONIC CLIMATE CONTROL PANEL TO RETRIEVE TROUBLE CODES. CODE EO22 - TPS SENSOR SIGNAL VOLTAGE IS LOW.CODE EO41 - CAM SENSOR CIRCUIT LOST

Question about 1990 Reatta

1 Answer

...and how to check tps voltage.with the voltmeter connected if you loosen the sensor screws you can move the sensor a little maybe enough to lower the sensor voltage.some of these are not

Question about 1993 LeSabre

1 Answer

...installing new TPS. Started engine, still high idle, still code 22. This happened to me, it was the sensor. From the sound of your problem, it sounds like the air flow sensor (relatively cheap

...TPS I only get half the voltage. I have two different problems show up the two times I have put an OBDll scanner on it. Problem 1 was the oil light came on. Problem 2 was car going into limp in mode. ...

...tps sensor on a 05 Buick LaCrosse CXL 3.8L serviceable? define serviceable? Is your vehicle electronic throttle controlled ? Do you know what that is ? Do you have a DTC - diagnostic trouble code ? ...

...sensor (TPS). Some sensors will not throw a code as they are pre-ignition sensors (TPS). Press the gas pedal to the floor and start the vehicle - this will bypass the TPS. If the vehicle starts clean ...

...new egr and can't clear code sorry forgot also replaced mass airflow the real problem Did you change the TPS (Throttle position sensor)? Low reference voltage or low signal voltage from TPS to ECM

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Buick LeSabre
2000 Buick LeSabre

1,731 Questions

1997 Buick LeSabre
1997 Buick LeSabre

1,603 Questions

1995 Buick LeSabre
1995 Buick LeSabre

1,084 Questions

2002 Buick Rendezvous
2002 Buick Rendezvous

1,091 Questions

1994 Buick LeSabre
1994 Buick LeSabre

904 Questions

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...