Questions & Answers for: if tps is good what else could it be

...such as hard shifts or the engine having to rev higher to shift, that usually a clear indication there is still something wrong with the TPS circuit even if the TPS itself is good. Hope this

...hook a lead to top or bottom terminal of tps. use other probe on center terminal of tps. move throttle plate slowly, if the needle on meter does not move at a smooth pace, then tps is bad.

...is pressed again. Start with checking the TPS, A bad TPS will cause this type of problem. Make sure that the wire harness is good and if it is, then good chance that the TPS will need to be

code 22 TPS circuit (signal voltage low). Check for sticking or misadjusted TPS. Check all wiring and connections at the TPS and at the ECM. Replace TPS if all else is good

...or misadjusted TPS. Check all wiring and connections an the TPS and the ECM. If all is good replace the TPS. I dont know how you found that the code is for the cooling system but it is not

...throttle. One good reason why it won't go. The TPS is connected on the throttle body. Have the TPS replaced and you'll be good. Hope this helps and thank you for using FixYa! Have a good

...for this code include: 1) Maladjusted TPS 2) Defective TPS 3) No +5 volt reference to TPS 4) TPS-return to ECM is shorted to ground or to sensor ground 5) Defective ECM Good luck, i hope this

good, touch one end to terminal #3 of the TPS connector (this will be on the right side) and touch the other end to a good ground source. You should get between 4.5v and 5.5v. If you don't you'

...constant ground clear the engine computer turn the key on push the gas pedal to the floor about 50 to 100 times if your 5v does not change and you have a good ground and the code returns the tps is ...

...to the throttle body. Check to see that the connector is installed on the tps and that the connector terminals are all engaging the sensor pins. If that is good, trace the wires and check for