Questions & Answers for: Geo tps Cars & Trucks

...is gone. I thought it may be getting too much fuel. The problem ultimately leads me back to the TPS, when I took the TPS off the car started running fine if I press the pedal slowly, any hard

tps sensor fail They are battery powered. When the battery dies, you have to change them. The reader for them to be tested is usually at a tire shop or dealer. why not post a real question, and not a ...

code 21 tps high voltage on a '95 geo tracker, how 2 fix? already replaced the tps & that did not fix the problem, any suggestions? very low idle & stutters when u hit the gas. Usually the ...

...some GEO;s but not toyota based Prizms) 45 is Idle Switch Circuit , grounded all the time. Part of TPS sensor. (too low) or Maladjusted. the TPS has a calibration procedure if no

Unknown wiring between the TPS and somewhere behind the TBI and MAP sensor. I have recently replaced the TPS sensor and forgot to mark each wire. The TPS has 4 wires that run from the sensor to a 6 ...

calibracion de tps con actron parametro de tps co elite auto scanner cp9185 actron what car, tracker, 97 G16b MPI, the TPIS calibration is ...

symptoms of a bad tps how you know if throttle sensor is bad old post. but.... a great question, but on a tracker , the TPS , has 2 parts inside cascaded as one part. so that makes answers harder. the

tps prob!! wont go to high idle,tps set at 1.0 volts cant get o ohms from test a and b terminals wont go to high idle this is the IAC failing not TPS, the tps only signals to the ECU that you are at ...

...it mean? Its a obd secondary code. http://www.robietherobot.com/metro/errorcodes.htm code 21.
TPS reads wrong, stuck high
usually means the ground wire to TPS is bad, cut or corroded.
on ...

how to replace the tps on a 1991 tracker? the one i bought has 4 wires the one on the tracker has 6 wires the 1991 G16a has a pig tail connector, must have 4 wires. and shares the Injector connector ...