...Check the parts on the airhorn behind all the airfilter ductwork. On one side you will have a TPS switch. It has 2 screws and 1 electric plug. If you take it off for a second you can see if ...
...sensor or transmission range sensor? ONe thing to check is that your throttle position sensor (TPS) is working as it should and that the electrical connections to it are clean and tight and that ...
have been told the TPS is bad. NOw the car will have been told the TPS is bad. NOw the car will not go over 25 is this the problem This can be the problem. The TPS is the part that replaces the ...
no power to tps TPS only has 5 volts reference voltage from PCM http://groups.yahoo.com/group/villagerquest/
...pedal is press on but dies when I lift foot off gas pedal. The switch at the throttle is called a TPS, throttle position sensor. It is fairly easy to change, has 2 screws and 1 electric connector. ...
Where is the TPS on a 2000 Mercury Villager? tps is throttle position sensor is located at the intake of the of the engine opposite side where the throttle cables end LOOK AROUND THROTTLE BODY THATS ...
What's a tps switch What's a tps switch TPS = Throttle Position Sensor. it used to monitor the position of the throttle in an engine. it usually located on the butterfy spindle so it can directly ...
what is a dropping resister or tps sensor? The tps is a throttle position sensor mounted on the throttle body. It measures the position of the throttle for the computer.
interchangeable parts are there other makes and models that have interchangeable parts, TPS, with a 1994 Mercury Villager yes, but don't buy a used tps, use a new one for replacement
Question about 2004 Sable
...Sable (3.0 V6 DOHC) I noticed it was idling higher, rougher than normal. To my discovery the TPS was bad. Shortly after a newer issue emerged. Now it's sluggish to accelerate. change the tps ...
Usually answered in minutes!
1,305 Questions
689 Questions
627 Questions
646 Questions
630 Questions