Electric water heater elements. How do you remove the heating elements on an electric water heater? after you shut off electric and water and drain tank they are unscrewed. they make a large socket ...
Question about Inline Water Heater - 120V
I have a Madison II tub that is only 2 years old. Inline water heater quit working. Need to remove it and can get 2 of the 3 fittings loose. These should only be hand tight but one of them won't budge
how do u remove the lower thermistat from model #E2F40LD045V you need to purchase an element wrench from a hardware or plumbing outfit, power down unit,remove 2 wires off element and use wrench to ...
Relief blowing out hot water every hour or so. Controller? Set at about 125. try replacing the pressure relief valve to do so turn off water to heater and turn off power or gas which ever you have ...
Question about 30 GAL ELEC SHORT Water Heater 6YR SC 82SV302
...do not use a torque wrench, just a big old wrench with a cheater bar if you have one and I assure you that it will come off. Regards, Joe PS a torque wrench is never for removal, only
Question about 40 Gallon FVR NATGAS Low WATER HEATER 6YR 22V40SF
relief valve on rheem 41v40 s-40f leaks Relief (pop-off) valves can be replaced. Make sure to get the right one. They unscrew from the unit. They are generally screwed in very tight, you may have to ...
... and replace. be sure to use a good teflon tape and tighten with pipe wrench. they don't need to be torqued to 900 lbs, just tighten until it feels tight to you. if it still leaks after testing, ...
I have a rheem heater M/N 81V40D how do I change the anode? Unless you see a large hex head socket to remove on the top of the water heater, many anode rods are built onto the hot side nipple. They ...
what wrench is needed to replace the heating element? Use standard element wrench from hardware store http://waterheatertimer.org/How-to-clean-sediment-out-of-electric-water-heater.html#Wrench ...
Question about RELIANCE ELECTRIC WATER HEATER
off button stuck on cannot unlock it need help There is a Allen wrench head hole on the bottom of the garbage disposal. with the right size Allen wrench turn the motor to free it up. unplug the ...
Usually answered in minutes!
335 Questions
282 Questions
267 Questions
250 Questions
267 Questions