...torque wrench. The top end comes off then the side cases, flywheel, flywheel electrics, clutch, shifter shaft, Crank drive gear and output shaft sprocket. Split the case leaving the gears on the ...
shaft seal and sprocket outer bearing and seal. A flywheel puller, impact driver, case splitter and torque wrench will be needed. Sorry for the pain. Could you take a moment and rate my answer? Thanks
torque wrench on the cylinder base nuts tighten down to manufacture spec's (24 ft lbs) Usually you can not get a torque wrench on the base nuts because the cylinder walls are in the way so I give it a
wrench on the other side to back it up. loosen any small chain adjustment nuts. pull the chain as far back as it can go all the time looking a the chain sag..you want to keep about 5/8 to 1 inch play.
...it 1/2 to 1 full turn. Hole the screw from turning while you tighten the lock nut (about 20 ft/lbs torque, slightly more than spark plugs). Now, go back to the cable adjuster, and unscrew it so the ...
Usually answered in minutes!
329 Questions
42 Questions
35 Questions
1 Questions