...torque wrench, be careful when you put it on, you don't want to over torque your aluminum case...you'll strip it, and wish you had spent the money on the torque wrench. If you plan on doing any work ...
...in it. The clutch hub nut torques 60-80 ft. lbs. left handed with one line of 271 Locktite. Make sure your torque wrench will torque in the left handed direction. Not all wrenches will. Good
...wrench in tight space.?many in. lbs. Torque values are : Two top bolts. 90-110 in. lbs. Four cover bolts, 90-120 in. lbs. I made a special tool to torque the oil pump bolts with. They're socket head ...
torque wrench and the primary locking bar for sure. The clutch nut is left handed threads. 60-80 ft lbs torque I think. Check on these torque values as this is what they are on the earlier models that
...torque wrench capable of putting 150-165 foot pounds of torque on the nut. You'll also need a torque that will torque to 60-80 foot pounds LEFT HANDED. Not all torque wrenches will torque left handed ...
...torque wrench capable of applying 150-165 pounds of torque to the engine sprocket shaft nut and 60-80 pounds LEFT-HANDED torque to the mainshaft nut in the clutch assembly. Not all torque wrenches do ...
wrench,. a torque wrench that will torque from 50 to 150 foot pounds in both the right and left hand directions, a front pulley locking device, and a special socket to take the large nut off the front
...foot pounds LEFT HANDED. Put one line of Loctite 271 red in each nut. You will need a torque wrench that will torque in the reverse direction. All torque wrenches won't do that. Good Luck ...
Question about 2000 FXDWG Dyna Wide Glide
...torque wrench with a 1/2 inch drive head and an axle torque adapter such as (HD-47925) which simplifies the belt adjustment procedure by allowing the cone nut to be properly tightened without having ...
Question about 2000 FXDWG Dyna Wide Glide
2015 Harley Davidson Road Glide, rear pivot bolt torque specs please. Edited question for clarity. Moved category to the correct one! In my day, we only used torque wrenches for cylinder heads. The ...
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions