with oil cooler lines lower trans lines you really need a repair manual for this kind of repair for torque specs and procedures It's a question of access. Look underneath vehicle for any obstructions
need to know what size wrench it takes to remove rear brake pads just hold the wrench up to it!!!!!!!!!!!!!!!
2004 Chevrolet HD 6L VORTEC: Replaced the knock sensor and am in need of the TORQUE spec for tightening the new knock sensor... HELP?? Thanks! the torque spec is 15 ft lbs. hope this helps. Thanks Ray
2008 chevy 2500 HD w/ Allison trans pan torque Hello. torque pan bolts to 7-10 foot pounds, install the drain plug and tighten to 25 foot pounds. Regards, Joe
torque for 2006 chevy 2500hd cv axle nut just make sure its good and tight,i have never had to use a torque spec for that.
...torque rating for a 2005 Silverado 2500HD spindle nut YOU DON'T TORQUE SPIDLE NUTS!! seat bearings with a wrench back off nut until just finger tight and then turn slightly tight, install cotter
Question about 2006 Silverado 2500HD 2WD
TORQUE WRENCH. I don't think that can be done because a torque wrench measures torque, or tightness. A torque angle gauge only measures the amount of degrees that the bolt is turned in relationship to
how do I change fuel filter on my 8.1L 2003 2500Hd Silverado? Under the driver side floorboard on inside of the frame rail, The fuel filter takes a 20mm wrench and the fuel line takes a 16mm wrench
Torque for 2006 chevy 2500hd cv axle nut 80-100 torque and be sure to replace the cotter key/ hammer the crush slot.
torque specifications transfur case Anon, Torque specifications Transfer case bolts. Check the attached links,instruction and guides, Good luck "I hope this helped you out, if so let me know by ...
Usually answered in minutes!
241 Questions
48 Questions
21 Questions
5 Questions
4 Questions