...Final torque is in 2 steps: 1st- 22ft. lbs. 2nd - 54-61ft. lbs ( if angle torquing in 2nd step, turn all bolts 80 to 85 degrees clockwise with an angle torque wrench. ) i hope this will help
torque wrench setting for cam cap bolts on Z24 Motor Can anyone tell me the torque wrench setting for the Cam cap bolts on a Z24 4cyl petrol motor Nissan Navara D21 11/1990 model I am helping a friend
...2000 model? somewhere around teh 15/18 lbs but i never use a torque wrench to be honest if you use a 3/8th drive rachet and hold rachet about half way down and just nip them this is the correct ...
in case if you really want to do by using a torque wrench it is tightened down in 2 steps. work from center to outer bolts. first torque spec is 9-26 inch pounds, then second step is 65-82 inch pounds
...13-16 ft lbs You should use a torque wrench that is sensitive at low torques. I bought an "inch pound" torque wrench for delicate items like injectors and just convert the foot pounds to inch
Question about 1994 Altima
...torque wrench. They are not supposed to be reused! Always use a new gasket and head bolts. Also referred to as studs. A digital torque wrench is easiest to use. Follow the tightening sequence in the ...
...procedure. Use a torque wrench to tighten the fuel rail mounting bolts in two stages. First, torque the bolts to between 84 and 96 inch pounds and then torque them to between 15 and 20 foot ...
Question about 1996 Sentra
...torque wrench to do this job. You miss understand why things need to be torqued . Torque is not specific to the vehicle its the bolt how hard what is thread pitch how many threads per in or mm how ...
Question about 1996 Sentra
Torque wrench settings for Nissan Ga14 motor and Ga16 Nissan head ...
...all bolts completely. Torque all bolts to 22 ft. lbs. (29 Nm). Torque all bolts to 54-61 ft. lbs. (74-83 Nm), or if an angle wrench is used, turn all bolts 80-85 degrees clockwise Torque
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,309 Questions
1,122 Questions
1,306 Questions