...head Hi I'm looking for cylinder head torque settings for 316/318 BMW 1992 E36. I've just removed the head to repair a valve seater. so i need to put it back 30nm 90 degrees, 90 degrees Renew
Question about 1992 3 Series
torque setting all models According to my service manual as follows. Cyl head to engine block (torx e12 M10 bolts) Stage 1 30nm (22 ft ? lb) Stage 2 + 90 degrees Stage 3 + 90 degrees Cyl head to lower
Question about 2003 FLSTC Heritage Classic
torque setting all models According to my service manual as follows. Cyl head to engine block (torx e12 M10 bolts) Stage 1 30nm (22 ft ? lb) Stage 2 + 90 degrees Stage 3 + 90 degrees Cyl head to lower
...torque settings on my bmw e36 316i 1991 j reg its not a 318i but parts of a 318i would thay fit a 316i and work fine Hi unsure what you mean by change the torque settings, if you mean on the head ...
torque settings for the head bolts. Thankyou Hi, I guess this is an E36. Head bolts should be renewed if heads been off, as they are stretch bolts. Tightened in 3 stages, 1st 30-35 nm 2nd + 90 degrees
torque settings for bmw 316 e36 big end bearings and main bearings hi for main bearings it is stage 1 : 25nm leave for 10 mins then stage 2 its turn 53 degrees for big end bearings it is stage 1 : ...
torque settings for a bmw318ti e36 m44 cylinderhead local part store can give print out for free
What is torque setting for bmw 320i-325i e36 prevanos Shop manual should have this.
Big end torque settings bmw 328i e36 Don't rely on web info for this--buy a cheap shop manual.
Question about 1997 318
Hi there I'm looking for torque settings on a BMW e36 318i for the cylinder head ,mains and big ends Try this chart for your information. http://www.championbrands.com/aera-torquespecs.pdf
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions