Questions & Answers for: toro mowers starting primer button

Our mower will not start. It acts like it is getting gas. There is a hole in the primer button. What should we try? hole in primer may not allow engine to **** in fuel, getting to much air.

...toro lawn mower. starts, but shuts off. Gas primer button must be pushed continuously to keep it going. EVen after 60 seconds of priming and the engine running it shuts off. What can I do? the ...

Toro 20016 will start but will only run for a minute. If I hold the primer button down all the way it will continue to run but will die if I release. I have cleaned the float and there are no leaks in

Toro lawm mower Engine starts and stalls within five seconds or less. Engine stays runnig only if I keep the primer button pushed in. When I release it, it stalls. the bulb is allowing air in some ...

...primer button to see if you squirt fuel. If it has no or little smell, continue priming and starting until you have fresh fuel. Replace the filter and plug. Disengage the pto ect ( saftys)before ...

...toro lawn mower will start with the primer button but quits after that gas runs out. Had this problem after I inherited the same mower. Take the carb off and remove the "bowl" using the bolt at the ...

TORO LAWNMOWER, MODEL 20330, GUARANTEED TO START BUT MINE DOES NOT START. IS THERE A PRIMER BUTTON UNDERNEATH SOMEWHERE???? A FRIEND OF MINE WAS ABLE TO FIND SOME KIND OF BUTTON UNDERNEATH AND ONCE IT

...primer button the will not start have depressed primer button the specified three times. Is there a start switch that I have forgotten about? Is the spark plug good? Check to see if it is getting ...

...toro lawn mower. starts, but shuts off. Gas primer button must be pushed continuously to keep it going. EVen after 60 seconds of priming and the engine running it shuts off. What can I do? may need a ...

my toro personal pace lawn mower starts hard and have to pump primer button to keep it running you need to open the carb and clean the jets