Remove the rear brake pads from the slots in the caliper bridge. Inspect the caliper bridge and rotor for damage and significant wear. Replace the rotor if it is warped or badly scored. Scoring of the
...brake pads Did you check to see if it was full of fluid and make sure the little plug on the master cylinder is plugged in also. If the brakes get to close to the rotors the sensors will get
brake warning light keeps coming on could be e-brake cable, brake pads, ABS sensor is dirty or going bad it depends on what kind of VW
...remove the old ones For front brake pads replacement you need only usually wrench set, inclusive 7 mm allen key also. But for rear brake pads replacement you need obligatory a special caliper piston ...
rear caliper piston with parking brake automatic adjustment!!! For front brake pads. You should buy the brake pads (with wear sensor). For change front brake pads you must raise vehicle, remove wheels
...with no obvious problems. Could you tell us what the light is indicating. It's an yellow warning indicator lamp. It lights when brake pads are weared. Now it's time to replace used brake
...pads i would like to change them myself if you look on the inside (engine side) of the caliper, you'll see two rubber plugs, one at either end of where the brake pad is. Prise them out & you ...
brake pads on the vw 2002 polo get sticky when driving.When driving and brake slowly the brakes work ok,but when you needed to stop urgently,the car brakes but the brakes doesn't release again.After +
brake pads on the vw 2002 polo get sticky when driving.When driving and brake slowly the brakes work ok,but when you needed to stop urgently,the car brakes but the brakes doesn't release again.After +
Why is there a sound like a cricket when the car makes a turn Probably brake pads are worn and when turning the bearings have just enough slack to allow the pad wear indicators to scrape the rotors.
Usually answered in minutes!
110 Questions
79 Questions
30 Questions
16 Questions
23 Questions