...rear of the headlight housing. don't screw with the housing because, its leveled for optimal sight range. I want to change my brake pads. What type and size caliper wrench do i need for a chrysler ...
...remove some (1/3?1/2) of the brake fluid from the reservoir. This is because as the caliper piston is pushed back into the caliper, brake fluid will be pushed back through the lines, back into the ...
...rear lenses can be removed by opening the trunk, remove the possible liner that covers the hex nuts on on the lamp housing behind the lens assembly and remove them, remove electrical connector and ...
...loosen emegency brake pads to remove rotor. do you need special tool there is no rear emergency pads, the pads that straddle the rotor are your rear brakes, the emergency brake shoes are behind ...
...remove the drum and brakes are fine u will have to check than if u broke one of the rear gears and froze the axle if the axle doesent move at all or makes grinding metal noise good chance rear gone ...
...brake pads. Also, check the front wheel bearings. check your hub bearings,most people call them wheel bearings if there good check brake pads. to check hub bearings you jack up front of vehicle , use ...
What is acceptable brake lining thickness front and rear? 1/8" PAD THICKNESS.
...If it's outside the car, then either the brakes were done poorly or the pads are defective. Assuming you had the front and rear brakes done. Could be the other brakes if only 1 axle was
...is a linkage? I dont think it's a break pedal it's probley pads or rear shoes, there are mmetal sencers that rub on the rotor when the pads get thin thats probley what your hearing check your
...rear brake rotors are warped. So you most likely have warped rear brake rotors. The noise may be that the wear indicators on the brake pads are touching the disks, indicating that you need new brake ...
Usually answered in minutes!
229 Questions
216 Questions
228 Questions
195 Questions
145 Questions