Questions & Answers for: Mercury tools remove rear brake pads

Question about 1993 Grand Marquis

2 Answers

...tools need to remove the rear brake pads If you are just removing and replacing the pads, you will need, i believe a 13mm wrench, a screw driver (flat head) and a "turn in caliper compression tool" ...

Ad

...tools required to compress the caliper rate as fixya if this is what you need. Thanks Remove the rear disc brake caliper (2K327). Remove the brake caliper bolts. Lift the rear disc brake caliper off ...

Ad

...rear driver side wheel is running hot, I suspect the brake is dragging ?? I used the spcl tool to wind the caliper piston back in..... what could I have missed. Did you drain excess fluid out of the ...

rear. It does mention a special tool....but you can use a c-clamp for the same purpose: RearTo Remove: Check the brake fluid level in the brake master cylinder reservoir. If required, remove the fluid

...the piston back into the caliper. There's square drive holes on each side to insert a socket wrench extension. Ask the parts store for a rear disc brake tool for rotating the brake piston back

...brake pad on this car Remove the wheel, remove the 2 bolts holding on the caliper to the caliper carrier. You will need a large C-Clamp or a cailper piston tool. Place an old brake pad against the ...

...jack both sides and make your decision about pads when you remove them. The E-brake drum surfaces inside the back of the rotors for the rear brakes usually always corrode and can't be turned. Good ...

Question about 1999 Sable

1 Answer

Rear pad replacement the caliper has 2 bolts that must be removed and the caliper then comes out.you will after removing the old pads need a caliper piston compressor tool or the new pads will not fit

Question about 2000 Sable

1 Answer

...brake job and am curious if there is anything specific to this model beyond the usual bleed and replace ? There is no need to bleed the brakes unless you get air in them. Just removing the pads and ...

Question about 2008 Milan

1 Answer

...remove the rear rotors. Some car models require readjustment of the Emergency cables before reassembly. In all, I would suggest that you be an observer for your first brake job. At least get a Video ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1999 Mercury Cougar
1999 Mercury Cougar

1,305 Questions

2001 Mercury Sable
2001 Mercury Sable

689 Questions

2000 Mercury Sable
2000 Mercury Sable

627 Questions

2002 Mercury Sable
2002 Mercury Sable

646 Questions

2000 Mercury Cougar
2000 Mercury Cougar

630 Questions

Top Mercury Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...