Questions & Answers for: GTCO toolbox 4

I can't get right proportion in X/Y axis in my Acad with DBIII if I get 4 points from perfect circle on this Drawing board, the result in Autocad 2002 is alway oval either in X or Y axis. Can you help

...Toolbox, and click Zoom, hand tool. 3. Click Calibrate rulers. 4. Place a clear plastic ruler under the on-screen horizontal ruler. 5. Click the up or down arrows on the Horizontal box to match one ...

Calcomp GTCO Roll upDigitizer I have a 30 X 36 roll up Iii digitizer and I can not get my computer to reconize it I downloaded the drivers and tblet works can Idenifey my digitizer but it will not ...

Came across a GCTO digitizer 3648 > AL. Got 15 > > med beeps. Followed trouble shoot in manual. Got to > Diode > > test. Recieved the following: > > > > 11101111 11111111

Super L III is not recognizing stylus Do you get 4 beeps on start-up? Is this a cordless or corded pen? Change the batteries in the cordless pen. Check the cable on the corded pen for breaks or cuts. ...

We can't activate the stylus. When our last estimatr was here everything worked fine. As soon as we went to use after he left we couldn't get to work. Any ideas? Plug in the Digitizer and make sure ...

how do i adjust the tone and volume of the board. its a Super L II Plus. Somehow I turned it off with the picture at the top. After turning it back on the only tone I can get is a sharp loud tone. I ...

I have a GTCO Digi-Pad Super L tablet with a 4-button cursor. I was having a problem getting the computer to see the tablet in startup so I upgraded to the latest software. The tablet starts better, ...

Super L III and pad system software The Pad system software V4.8 does not have Super L III in the list. What is the compatible one? The drawing board works just fine when run set up test with ...