...the manual for the location of the glass, in the maintenance section, if it has toner on it copies will be black or dark, other wise the scaning glass is bad ...
...dark backgrounds. I have replaced both the toner and drum units twice. When I check the drum after printing the drum is covered in toner! Any ideas what could be causing this. Many thanks in advance. ...
Question about Elite XL 608 Laser Printer
...dark rest lt. print. Already cleaned mirror & reshaken toner new toner less than 3 months old,typcial usage 12-15 mth.608xl elite gcc printer. 1/3 page dark rest lt. print. Already cleaned mirror & ...
...dark enough I installed a new toner cartage but it still does the same thing? If you have installed the toner cartridge correctly then it is a hardware problem called the Fuser and is the most common ...
Question about Panafax UF-595 Plain Paper Laser Fax
...dark band on left hand side of incoming faxes and confirmation faxes. I pulled out toner and there is a black bar on whatever part is under the toner. Fuser maybe? Can I clean that? Or do we need to ...
...dark faded, but continuous vertical streaks about 1 - 2" wide on right and left sides. Print is legible, even in faded areas. Open top cover and remove toner, shake toner cartridge and try a test ...
sheets of anything. While printing, open the cover and pull out the toner. Look down at the paper. If you see a dark streak, you have to replace the toner. If the page is streakless, replace the fuser
...toner, which results in dark copies. To fix this, you have to reduce the contrast (to minimum). Also, make sure that there is no excess toner within the toner supply unit. Hope it helps! Good Luck! ...
...dark with text Pages and i have decrease the toner density to 1, but still not avail. you will probably need a maintenance kit. After a while the toner roller and fuzer rollers wear down and allow ...
Question about estudio 305 Copier
...toner by hand print is dark press 0 & 5 simmilutely m/c. on type 200 press start m/c. is moving you see screen when figure is going 230 to 245 then press enter then press intruppt hope your m/c. ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions