Questions & Answers for: Jeep tone wheel

Ad

...tone wheel) behind the wheel hub. Actually, u can just check under the hood, the abs system has a lot more to its components than regular brakes. ABS system has a pressure modulator, along w/ the 4 ...

Ad

...THE ABS TONE RINGS ON FRONT CV AXLES..OUT ON AXLE AXLE END NEAR WHEEL BEARING..HAVE SLOTS OR TEETH..ONE MAY BE CRACKED AND GIVING AN ERRATIC SPEED SIGNAL TO ABS MODULE..CAN BE AN INTERMITTENT ...

Ad

Question about 2007 Grand Cherokee Overland

1 Answer

camshaft position center location on 2003 jeep grand cherokee overland v8 4.7 drivers side front of the engine i believe it is on the timing cover but the camshaft tone wheel is on the left side head.

...damage the tone wheel or the sensor. In the ZJ-Secc-5-Brakes (page 25) can find information about the sysrtem and sensors location. I really hope helped with this; remember rated this help. Good

Question about 1994 Grand Cherokee

1 Answer

...it could have come loose. The sensor "reads" a tone wheel that is part of the flywheel. If the gap is to wide it cant read the tone wheel and output to the computer the proper signal to fire the

Question about 1995 Grand Cherokee

2 Answers

...tone wheel) passes by a stationary magnetic sensor (wheel speed sensor). The CAB converts the AC signals into digital signals for each wheel. The front wheel speed sensor air gap is NOT adjustable. ...

Question about 2000 Grand Cherokee

2 Answers

...Tone wheel/pulse ring damaged Sensor ground circuit open 5 volt supply circuit open Irregular LAB scope pattern of CMP signal Wiring harness intermittent problem Stay signal from crankshaft position ...

Question about 1999 Grand Cherokee

1 Answer

...tone wheel. The tone wheel is located at the front of the camshaft for the right cylinder head. As the tone wheel rotates, the notches pass through the sync signal generator. The pattern of the ...

Question about 1995 Grand Cherokee

1 Answer

wheel, or the ABS tone rings themselves rusting too much. The tone rings are the toothed rings at the end of each of your axle shafts. The clockspring would have to be replaced, but the tone rings can

...TONE WHEEL PERFORMANCE P0707 - Transmission Range Sensor Circuit Low Input Possible causes - Faulty Park/neutral position switch - Misadjusted park/neutral position switch - Park/neutral position ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...