Oiling my Janome Gem Gold Where are the correct places to oil my machine? What about lubrication on the hand wheel? The motor seems to "groan" a bit when I begin to sew, and needs a nudge with the ...
Question about Jem Gold 660 Sewing Machine
My Janome 10000 is coming up with an error that asks 1. is there some thing jammed in the machine 2. is the needle bent 3. is the material too thick then I noticed the hand wheel was very tight. How ...
Hand wheel will not turn. Frce the balance wheel backwards to unjam a possible thread jam
hand wheel spins the hand wheel spins and doesn't move the needle up or down and also doesn't pick up the bobbin thread You may have it locked in to bobbin wind mode.
the hand wheel is not moving the needle at all Hi I was unable to move the needle at all using the hand wheel so was unable to check the alignment of the needle as you spoke of Check the hand wheel. ...
hand wheel not moving I used the bobbin winder and returned it back to its position and it was then the hand wheel didn't work and needle doesn't move at all sounds as though the hand wheel at the ...
...tone or fabric colour thread new thread. Then take a bobbin left hand some 3 or 5 wring bobbin thread for right hand wring opposite side then turn the bobbin take on one big needle or screw driver ...
Question about Memorycraft 6500P Computerized Sewing Machine
Hand wheel won't move.Scissorbutton wont work. Repairing a Janome or New Home Sewing Machine ... www.thriftyfun.com/Repairing-a-Janome-or-New-Home-Sewing-Machin... Question: Memory Craft Machine Won't
Question about Memorycraft 6500P Computerized Sewing Machine
janome platinum 720 jammed wheel jammed wheel on sewing machine Force it hard in the direction of travel using the handwheel. You can't break it. The remove needle and thread and run at full speed for
Question about Memorycraft 6500P Computerized Sewing Machine
Janome Platinum 720 sewing machine wheel is jammed The wheel is locked and cannot make the needle rise or go down. I have taken the plate off and cleaned the bobbin area. MIGHT BE A TIMING PROBLEM
Usually answered in minutes!
565 Questions
193 Questions
102 Questions
90 Questions
79 Questions