Questions & Answers for: Jeep together again

...stops working Inspect all wiring under the dash and hood, check for loose connectors and water intrusion. Should fix it just from you taking each connector apart and putting them back together

...again,but no fire this time,any idea's any spark from the wire from the coil ??? to teh distributor coil this time perhaps. If you replaced the ignitor then the coil will be stressed from higher ...

...again.. when it does pu the numbers together and it will be like lets say blinks 5 times.. pauses then blinks 5 times again.. that wil be 55 that will say no codes are present that rea computer ...

remove dash, twist cannectors behind dash and put back together. All gauges will e working again. 10-15 mins tops This should just be a fuse, if not check the harness that plugs into the circut board

...again. Now it has stopped blowing all together. Could it be the resistor my controls for the heater and air conditioner isnt working it seems like there is no power getting to the controls. ive ...

together and all works again took longer to get the boot back on than fixing the wire check your wires between the driver side door and the cab. i had the same prob. and that was the cause. inside the

on after i charged it. What could cause this and should it be safe to drive just by putting it back together. Yes, put it back together and see if it comes off again. You may have over-charged your AC

...if u pop off the cap check the little tabs inside try cleaning them off and putting it back together and try checking for spark ...

...since it worked went out then came on again then stopped working all together? Thank you see if the firewall connector is not having some issue i think this model has a block connector

...together also horn on steering wheel stopped working at the same time how can i reset it to work again. Changed keys battery and ignition switch. Transponder key with no buttons works just fine. One ...