...timming marks on the cam gear and crank gear, you can use a strate edge to chk. to see if you got them lined up right, there will be a mark on a tooth on one gear, and the other mark will be between ...
i set timing on a 1988 chevy s10 please show pics get timing light and attach to #1 cylinder unhook timming comp. mark pully at T.D.C (top dead center) and crank engine. adjust distributor till #1 and
MARKS CAM SHAFT the timing is set to 8 degrees at 700 rpm...if it helps any Are you putting in a new timming chain? If so it should have came with a new crank gear witch has the mark on it, it will be
...timming marks on the front engine block. if you see it you will need a timming light to set it very cheap to buy. if you do not see any timming marks and you have a distributer losen it a little but ...
...timming back far to left of marks on top of pully. and it runs better but still glows header when under load Might be a plugged catalitic converter. Your timing is way retrded which is why the ...
my cam shaft timming gear and my crank shaft timming gear dots line up and my harmonick balancer timming mark is on 0 which way should my rooter button face towards number 1 or towards rear of engine ...
I have a 97 cavalier and its standard it has a small tranny dip stick at back of tranny how do i check it pol it out wyp it of . look to se whar the full mark is stick back in all the way pul it out ...
...timming marks are or details to make sure we doing it right mak sure the dot on crank gear is at 12 oclock and the dot on the cam gear is at 6 oclock.or just make sure the dots line up when the chain ...
Where is timming mark all timing marks are on the lower belt pulley
...timming belt mark I can give you the marks, but, w/o proper procedures, I'm afraid your going to have problems. Do you have a good repair manual? My database has a long drawn out procedure. I don't ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions