the cylinders are probably too low or high in compression and if it's backfireing then the ignition timming could be off. I would take a compressin test of all cylenders and if they are all in range I
1991 mazda b2200- timing belt changed need help in alligning the timing marks after changing the timing belt. If the crank is set at TDC what should the cam pulley mark be at 0-1-2-3? The keyway and ...
...timing is right. Also I am going to replace the timing belt while I am at it.....Thanks , Roy the timming should be set @ 6BTC you will need a timming light to check it. You should go buy a manual ...
I NEED TO SET THE TIMMING BELT ON MAZDA 2000 TRUCK cant find the timming this site will answer all your questions http://www.mazdatruckin.com/B2200//B2200_Timing_Belt.html
find timming marks mazda b2000 this site will answer your questions good luck http://www.mazdatruckin.com/B2200//B2200_Timing_Belt.html
...Any idea what the problem is. check the crankshaft sensor as this is where the signal to fire comes from i cant find timming mark of cam saft what can i do for set timming ,for mazada astina bg ...
Timing mark on crank pulley jumps abruptly about I Installed new timing belt and on completion, I put the timing light on to check the timing, I noticed only one timing mark white, no yellow. Also on ...
After installing a timing belt I checked with a timing light and found it was on the mark but when I slowly increasing the RPM's after first half inch climb the mark abruptly jumped about an inch ...
how do you time the motor You need to find your timing belt or chain. There are two marks on the pulleys. They are usually straight up, or 12 o'clock. Both have to be aligned perfectly on the marks. ...
Question about 1988 B2200
My 1992 Mazda B2200 Truck.When i drive it for awhile ok.When I stop after 10 minutes.Does not want to start up. weeak fuel pump turn ur key on and off three tims and the start
Usually answered in minutes!
738 Questions
692 Questions
544 Questions
609 Questions
615 Questions