Questions & Answers for: Daewoo Lanos timming mark

...similar problems, and jpossible solutions. Thanks Gary if the car was fine before you replaced the timming belt then it sounds like its still 1 tooth out either 1 forward or 1 back. hope that helps ...

...Mark. need to check the timming belt. remove top plastic cover to the timming belt have someone turn the engine over see if cams are turning, check to see if cam gears still line up. hope is is the ...

...timming marks on cams face each other 3 and 9 o clock crank mark at about 6 o clock mark in cover and sump auto adjuster arrow should be in v mark to set this requires turning water pump by loosening ...

...my problem is that i replaced the head gasket and the heads were rebuilt i also replaced the timming belts and i tryed to turn it on and it din't. i veryfied all the marks from the timming

...but nothing since. What am I missing??? did you turn over any gears while belt was off to align timming marks? if so did you encounter a resistance and forced the gear over with a bit more than ...

Any ideas???? was washer put back on the crank correctly? Is there spacers or gromits that hold the timming cover on? Sometime I run car before I put all excesserys back on just to see that problem..

...mark more than exhaust. if you have tensioner that needs retaining pin in when installing you fit belt while aligning timming marks fit tensioner as last spot to feed belt on with retaining pin in ...

...positions both lobes on number 4 cylinder face each other (point towards centre of engine)when timming marks on cam gears are lined ...

daewoo lanos 1.5l timing belt marks Answer If this is a single overhead cam, possibly A15SMS (engine type): If you have everything stripped down and can see the crank shaft gear, you will notice an ...

...getting it repaired (valves replaced and possibly guides) see some of my other posts for cam belt timming marks locations etc... depending what motor is in your vehicle twin cam or single? and if ...