Questions & Answers for: Jeep Wrangler timing cover

Would like to install locking gas cap cover on 08 Wrangler. How does original come off? Don't want to force anything until I'm sure. Thanks. Does your Wrangler have a cap that is attached with a ...

...timing is set? I know about the vacuum advance on the distributor, are the 3 vacuum valves on the rear of the valve cover also supposed to be disconnected? What should it be set at for 9,000 feet? ...

timing cover is leaking oil betwwen cover and block Disconnect the negative battery cable. Remove the drive belt(s), fan and fan shroud. If equipped, remove the accessory drive belt pulley. Remove the

...timing case cover and look at the chain. if the engine has 200K miles or better, I'd replace the chain, as at that point, most chains have sufficient wear to justify replacement even in engines that ...

...timing cover and a small slot th the pulley flange do this remove no 1 plug and get no 1 piston coming up on compression using a piece of copper wire in the plug hole determine when the piston is at ...

I have a 1988 jeep wrangler yj. Im leaking oil out of a hose coming from my valve cover into my air cleaner. I'm also leaking a little out of valve cover where the pcv valve plugs in. and I also ...

...timing case cover is used for reference when timing the ignition system. A milled index notch in the vibration damper is used to align the No. 1 cylinder ignition position of the crankshaft with the ...

beeping with brake light flashing happened after brakes were slammed on the operators guide covers that. read that yet? brake failure. brake inspection time... some cars the fluid level and hand brake

timing belt cover won't budge timing belt? on a Jeep? 05 wrangler what engine is this>? ah the 2.4L front cover Before servicing the vehicle, refer to the Precautions section. Remove the crankshaft

...CKP sensor timing.

the 4.2liter has distrib timing.
see below.
my guess is you have the instructions and
get lost at the find VACUUM switch on top of valve cover