oven door is loose and does not close tight against the gasket. Can you recommend a method to tighten the closing mechanism please? Hope this helps (technique used on EOG9330XN): 1) With the door open
neff b1421 my oven door won't close properly and is losing heat does anyone know how to tighten the hinges - Thanks!! Replacing the door hinges is the only solution to this problem.
..."sagged" a little or something causing the door to stick a bit when pulling open. Can hinges be tightened, replaced, etc.? Or can the problem be something else? Clsoming the door appears to not ...
Question about HBL 742 / HBL 746 Electric Single Oven
...Oven Door Problem - doesn't close at top We had the hinges replaced; worked for a few weeks, now the same. Cannot even clean oven - door will not lock ! We read the 'hinge/screw tightening' solution, ...
...hinges for this model. Oven is good except for this. Are hinges available? Post your model number and I'll give it a try. This is a 'off brand' oven and the parts for it here are not available. I ...
...oven door will not close all the way - what do I need to adjust? tighten the screws in the hinges and if there tight? then the door is sprung and needs to be replaced or straightened tighten the ...
oven door won't stay tightly shut No where in the manual does it show how to adjust or tighten the hinges, I took the door off and reinstalled so they are in correct position? Oven door hinges are not
oven cavity. Top case has to come off using, likely, security torx screw drivers. Remove the top hinge. Remove the bottom hinge. Door falls off. Replace the front panel of the door. Reinsert the lower
...tighten this door up ,the one i have comes down just a little and the light comes on Hello, Welcome to FixYa. Yes this has been a fairly common issue with the Thermador wall ovens as well as their ...
Question about SEC271BS Stainless Steel Single Oven
...oven out of its enclosed space and unscrew the sheet metal siding in order to gain access so that you can unhook the coil spring attached to hinge. I found that one of the small machine screws has ...
Usually answered in minutes!
924 Questions
608 Questions
343 Questions
293 Questions