Questions & Answers for: tighten loose alternator belt 1993

...Alternator toward the center of the engine. It's on a spring loaded arm. Get your socket on the center nut of this pulley. Slowly pull the ratchet toward the center of the engine. The pulley will ...

test it It sounds like a loose alternator belt. When the engine is running at highway speed, the belts get looser with heat and they will slip a bit. Either get a new belt or tighten the one that's on

...tighten the alternator belt.it is making squeeking noise pull up on the alternator and then tighten the bolts/ For instance you can have some get a pry bar and pull it up so its tight/please rate my ...

...bolts on alt loose then tighten adjusting screw on tensioner i think its been a while since ive worked on one but thats the idea dont over tighten u want a little movement when u pull up n down on ...

...loose, tighten it (if that is possible). (On older cars, this is possible, but you may have a serpentine belt with "tensioner" which is not easy to adjust the tension.) On most belts, there should be ...

...alternator belt is a little loose. My daughter's car did that right after I changed the belt, The new belt stretched a bit, and a couple weeks later, it was sqealing. I tightened the tensioner up a ...

...Tighten the alternator nut to 19 ft. lbs. (26 Nm). Connect the wire to the terminal and tighten the nut. Engage the multi-pin connector to the alternator. Install the cruise control actuator. Install ...

its the alternator belt,and you will have to look under the alternator there you will find the manual tensioner you have to loosen the mounting bolt in order to tighten it with the long tensioner bolt

...tighten both through bolts up. For the thick belt, loosen the through bolt on the alternator, then turn the long bolt at the bottom, front of car, of alternator clockwise. you have to locate the main ...

...the hood, behind the main pulley. The main pulley accommodates the alternator belt, ac belt and power steering belt, if any. The water pump and timing belt are both enclosed in the timing belt