...chain is loose how do you tighten it?? for some reason it doesn't tell you in a manuel. thankyou tom please excuse my english.There are two locknuts on the cover of the chain sproket(release them a ...
...tighten chain .. too droopy. i am a 66 yr old female i do not know how to tighten my elec. chain saw chain it isnt too droopy just a small amount. i tried to tighten the screws where the man at a ...
...tighten the chain. don't tighten it too much! leave a little "play" - tighten down the nuts. plug in the saw and start it. if the saw has a chain oiler press the oiler a few times. as you use the saw ...
tighten chain Thanks for contacting FixYa. I was just reviewing some of the old unsolved problems and wanted to make sure your question gets resolved. Chain can be correctly tightened by loosening the
...tighten the chain. procedure for tightening chain. loosen the chain guard nuts, tighten the bar adjusting screw by turning to the right or clockwise, the chain has to roll freely around the ...
tighten chain How to tighten chain to tighten the chain on most saws you loosen the lock nuts on the cover that goes over the clutch and on the side of the bar where the bar meets the saw you will ...
Question about (16") 3.5 HP Electric Chain Saw - WG303
...tighten chain after removing the cover All the saws I use that do not need the cover removed to tighten the chain. If the tightening parts are in the cover you can't adjust the tension with the cover ...
...Tighten the tightener screw until the chain is tightened leaving a little slack, then tighten the two hex nut. Replace the side cover. When you pull the chain down away from the bar, it should have ...
Question about 338xpt 14" Gas Chain Saw Husky In Box
...middle of the chain on the top of the bar. Tighten the chain screw until the chain is loose enough to raise the chain up about 1/2 inch then tighten the mounting nuts tight. Then see if it is ...
Question about 338xpt 14" Gas Chain Saw Husky In Box
...tighten chain rev. engine chain will just about come okk -tighten chain rev. engine same thing. you have to use the tension screw to move the cutter bar to tighten the chain then you do up the bar ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions