Tighten water pump mounting bolts to 40 N·m (30 ft. lbs.) torque. Position bypass hose clamp to bypass hose. Spin water pump to be sure that pump impeller does not rub against timing chain case/cover.
...chain guide. Tighten the bolts to 28 N·m (250 in. lbs.). CAUTION: Overtightening the tensioner arm torx® bolt can cause severe damage to the cylinder head. Tighten torx® bolt to ...
...chain tensioner and install the two (2) remaining bolts. 7. Tighten the pump and tensioner retaining bolts to 21 ft lbs in the sequence shown in attached photo. 8. Install the secondary timing chain ...
chain This is a specialty tool and you can probably borrow or rent one from Advance Auto parts or Auto Zone.They are also not to expensive to buy but since you will probably never use it again I would
...Tighten the bolts to 30 ft. lbs. (40 Nm) on pushrod engines, 40 ft. lbs. (54 Nm) on the 4.7L engine. Spin pump to ensure the impeller is not rubbing against the timing chain case. When installing the ...
Usually answered in minutes!
2,049 Questions
1,616 Questions
1,378 Questions
886 Questions
1,005 Questions