Questions & Answers for: Volkswagen Golf tighten belt

...available? If the Tensioner will not Tighten the Belt, It will be one of two Things. Either the Belt is too Long or the Tensioner is Bad and needs to be Replaced. Please Rate My Response!

belt off and need to know where the timing marks are Cylinder Head Assembly: Specifications Torque & Tightening Sequence Tighten cylinder head as follows: Stage I .................................

...4. Put on the new belt. 5. Slightly tighten the 13mm bolt, and use the crescent wrench to tighten the belt (using the half gear/half nut tightening assembly) 6. Tighten the 13mm. 7. Tighten the

...belt has come off how do you tighten I loosend both bolts on the alternator but it doesnt move. thats because there is a tensioner pulley it is likely sprung loaded to tension the belt at times they ...

tighten my fan belt replace belts they are glazed from slipping and better to replace them now then damage your cooling system or boil over and trash your motor Chances are the belt should be replaced

...belts longest lenth has about 1/2 inch of movement in/out.then tighten adjusting bolt up tight,check movement in belt again,if okay,tighten main holding bolts.check again if all fine.JOB

to fit drive belt release bolts on alternator and swing it inwards then replace belt and pull alt outwards to tighten,longest stretch of belt should flex no more than 1/2"after all bolts are tight.

...it in towards the block,refit belt and lever out the alternator to tighten belt when you tighten bolts.the longest part of the belt between pulleys should have 1/2 inch play max.DO NOT

...replaced. I need to know how to do this? Is there a drawing available? look for the belt that runs the alternator find tesioner for belt loosen it remove replace and tighten belt till it hes a lil ...

...of crank shaft and camshaft  not leaking if so renew them.renew the tensioner and the belt. tightening the belt on the tensioner there are two tiny holes by using a tool fitted in the holes