Questions & Answers for: Toyota Corolla tighten belt

...belt. do the reverse on installation. remember to tighten all bolts of the adjuster and alternator after tightening the belt. tnx 4 using fixya, drcool Loosen the alternator bracket bolt to the side ...

Ad

Question about 2003 Corolla

1 Answer

You shouldn't need to most of the time all you need is a 15mm wrench. Use it by turning the spring tightener inward toward the center of the motor than the belt should come off. Also when you take it

Ad

...I think its the alternater belt(excuse my spelling) it gets faster when i accelerate. Does it need tightening. Also cv joints what happens if they are left with the clicking noise for too long. Does ...

Question about 1993 Corolla

2 Answers

tighten that belt becasue it also runs the water pump and if u over tighten it and cause the pump bearing to fail and an water pump is an major repair on these engines because the water pump is behind

...screeching when engine is warming up on 2006 corolla first tighten your belt then if that doesn't help run water from a hose onto the belt while the car is running if the noise stops replace the ...

engine stalls when alternator belt tightens or car Why engine stalls when alternator belt tightens or car in drive and or reverse mode? I replaces the crank shaft bearings and start the engine but as ...

...JUST CHANGE MY FAN BELT,NOW ENGINE LIGHT COMES ON if engine light was off before belt change, and now its on. the belt may be loose on alternator pulley. or the belt tensioner is bad. tighten up

bolts for the alternator, then lever the alternator away from the block to tighten the belt.you have 2 bolts holding the alternator and 1 holding the adjusting arm.(loosen both ends/lever/then tighten

...Tighten the mounting bolts evenly to 11 ft. lbs. (15 Nm). Install the timing belt covers, making sure they are properly seated and not rubbing on the belt or other moving parts. Install a new seal ...

Question about 1994 Corolla

1 Answer

...and the alternator belt is very tight. Then tighten the bolts. Make sure that it didn't slip while tightening them and then start the car and make sure that the belt is tight and not

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 Toyota Corolla
1998 Toyota Corolla

1,231 Questions

2003 Toyota Corolla
2003 Toyota Corolla

1,240 Questions

2005 Toyota Corolla
2005 Toyota Corolla

1,236 Questions

1994 Toyota Corolla
1994 Toyota Corolla

819 Questions

1996 Toyota Corolla
1996 Toyota Corolla

767 Questions

Manuals & User Guides

Loading...